2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 972
DTC C0590 01
- Right Rear Actuator Circuit - Short To Battery
DTC C0590 02
- Right Rear Actuator Circuit - Short To Ground
DTC C0590 04
- Right Rear Actuator Circuit - Open Circuit
Diagnostic Fault Information
Circuit/System Description
The electronic suspension control module (ESCM) commands variable levels of pulse width modulated current to each damper in response to rough
road, or abrupt steering maneuver driving conditions. The ESC module continuously compares each dampers command state with the state of their
feedback circuits to ensure they agree.
Conditions for Running the DTC
* Battery voltage is between 9-16 volts.
* Ignition ON for 30 seconds
Conditions for Setting the DTC
* The damper coil or the circuits to the coil are shorted to ground, shorted to voltage, or open for 3 consecutive ignition ON cycles.
* The vehicle must be driven over 4.8 km/h (3 mph).
Action Taken When the DTC Sets
* The driver information center (DIC) displays the SERVICE SUSPENSION SYSTEM message.
* If the DTC symptom 01 is stored, the ESC system is disabled.
* If the DTC symptom 02 or 04 is stored, the suspect damper is disabled.
Conditions for Clearing the DTC
* A current DTC will clear on the next consecutive malfunction-free ignition cycle.
* A history DTC will clear after 50 consecutive malfunction-free ignition cycles.
Reference Information
Schematic Reference
Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Diagrams/Electrical Diagrams/Electronic Suspension Control)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Electronic Suspension Control Description and Operation (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Description and Operation/Electronic Suspension Control Description and Operation)
Electrical Information Reference
