Moveable Window Schematics (See: Windows and Glass/Windows/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Power Windows Description and Operation (See: Windows and Glass/Windows/Description and Operation/Power Windows Description and
Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Observe the operation of the power windows while commanding each window UP and DOWN by using their respective window switches, each
window should perform the UP and DOWN function.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
2. Connect a test lamp between control circuit terminal A and control circuit terminal B.
3. Ignition ON, command the window UP and DOWN by using the door switch. The test lamp should turn ON when commanding the UP and
DOWN states.
锟斤拷 If the test lamp is always OFF during either of the commands, test either control circuit for a short to ground or open/high resistance. If the
circuits test normal, replace the door switch.
锟斤拷 If the test lamp is always ON, test either control circuit for a short to voltage. If the circuits test normal, replace the door switch
4. If all circuits test normal, test or replace the window motor.
Component Testing
Important: When performing the following tests, make sure that the window motor is not all ready in the position the test is attempting to
produce.
1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
2. Install a 25A fused jumper wire between the control terminal A and 12 volts. Momentarily install a jumper wire between the control terminal
B and ground. The window motor should perform the UP or DOWN function.
锟斤拷 If the function does not perform as specified, replace the window motor.
3. Reverse the jumper wires; the window motor should perform the DOWN or UP function.
锟斤拷 If the function does not perform as specified, replace the window motor
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Front Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Front Side Door Window
Regulator Motor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for DDS and PDS replacement, setup, and
