Wednesday, February 2, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1672

2010 Cadillac Truck SRX FWD V6-3.0L Page 1672



P0713



The TFT is 174掳C (345掳F) or greater for 1 minute.



Action Taken When the DTC Sets



* DTCs P0711, P0712, and P0713 are Type B DTCs.



* The TCM defaults the TFT to the TCM Temperature.



Conditions for Clearing the DTC



DTCs P0711, P0712, and P0713 are Type B DTCs.



Diagnostic Aids



The transmission control module (TCM) temperature sensor is located inside of the control solenoid valve assembly and its output should resemble



that of the transmission fluid temperature (TFT) sensor's output.



Reference Information



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -



Automatic Transmission/Electronic Component Description) for control solenoid valve assembly



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine idling at operating temperature, verify the scan tool Trans Fluid Temp. parameter is between -74 and +174掳C (-101 and +345掳F).



瀚慖f not within the specified range, replace the control solenoid valve assembly.



2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid



Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 25掳C (45掳F) of each



other, and the Trans. Fluid Temp. and TCM Power up Temperature parameters should be within 25掳C (45掳F) of each other.



瀚慖f both are greater than the specified range, replace the control solenoid valve assembly.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Important:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs.



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: