Wednesday, February 2, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1754

2010 Cadillac Truck SRX FWD V6-3.0L Page 1754



Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General



Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Control Valve Lower Body and Upper Body Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Valve



Body/Service and Repair/6T70/6T75 - Automatic Transmission/Control Valve Lower Body and Upper Body Replacement)



* Low and Reverse Clutch and 1-2-3-4 Clutch Plate Removal (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service



and Repair/Overhaul/8. Low and Reverse Clutch and 1-2-3-4 Clutch Plate Removal) and 3-5-Reverse and 4-5-6 Clutch Housing Disassemble



(See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Overhaul/41. 3-5-Reverse and 4-5-6 Clutch



Housing Disassemble)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement,



setup, and programming



P0798



DTC P0798 or P0969-P0971



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0798



- Pressure Control Solenoid Valve 2 System Performance



DTC P0969



- Pressure Control Solenoid Valve 2 System Performance



DTC P0970



- Pressure Control Solenoid Valve 2 Control Circuit Low Voltage



DTC P0971



- Pressure Control Solenoid Valve 2 Control Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The shift control solenoid (SLC2) is installed on the front valve body. The solenoid linearly control hydraulic pressure in response to signals output



from the transmission control module TCM. Through this, the SLC2 controls operating hydraulic pressure to the clutch 2 for smooth shifting.



According to each shift control solenoid assembly, the transmission shifts from 1st gear into 6th gear and vice versa. As a fail-safe function, if any



shift control solenoid assembly abnormality occurs, the TCM will disable the current to the solenoids.



Conditions for Running the DTC