2010 Cadillac Truck SRX AWD V6-3.0L Page 713
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance
3. Connect a test lamp between the control circuit terminal A and ground
4. Ignition ON, command the Brake Lamp ON and OFF with a scan tool, the test lamp should turn ON and OFF when changing between the
commanded states.
瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K9 BCM.
5. If all circuits test normal, test or replace the E5 tail lamp.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Tail Lamp Replacement (See: Lighting and Horns/Tail Lamp/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming
B3883
DTC B3883
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3883 02
- License Plate Lamp Circuit Short to Ground
DTC B3883 04
- License Plate Lamp Circuit Open
Diagnostic Fault Information
Circuit/System Description
The headlamp switch is supplied with ground at all times. When the headlamp switch is placed in either the park or low beam position, the BCM
responds by applying battery voltage to the license plate lamp control circuit. This energizes the left and right license lamp.
Conditions for Running the DTC
Headlamp switch in park or low beam position.
Conditions for Setting the DTC
B3883 02
The BCM detects a short to ground on the license plate lamp control circuit.
B3883 04
The BCM detects an open /high resistance on the license plate lamp control circuit.
Action Taken When the DTC Sets
