2010 Cadillac Truck SRX AWD V6-3.0L Page 283
The keyless entry control module detects an open/high resistance on the right rear door latch motor unlatch control circuit.
Action Taken When the DTC Sets
The affected door will require a pull of the exterior door handle to unlock the door and a second pull of the exterior door handle to open the door.
Conditions for Clearing the DTC
* This DTC will be current for as long as the fault is present
* When the fault is no longer present, the DTC will be a history DTC
* A history DTC will clear after 40 ignition cycles
Diagnostic Aids
DTC B1330 03 and B251A 02 may sent concurrently, correct the condition for setting DTC B1330 03 first before performing diagnostics testing
for B251A 02. Refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code
(DTC) List - Vehicle) to locate the correct procedure.
Reference Information
Schematic Reference
Door Lock/Indicator Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Door Lock/Indicator Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Power Door Locks Description and Operation (See: Body and Frame/Locks/Power Locks/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition OFF, with the doors closed and locked, approach the vehicle with the keyless entry transmitter and pull the exterior driver door
handle. The driver door should unlock and unlatch allowing the driver door to be pulled open.
瀚慖f the driver door will not unlock and open with a single pull of the exterior door handle, refer to Driver Door Latch Malfunction.
2. With the doors closed and locked, approach the vehicle with the keyless entry transmitter and pull the exterior passenger door handle or the
exterior left rear door handle or the exterior right rear door handle. The appropriate door should unlock and unlatch allowing the door to be
pulled open.
瀚慖f all the passenger, left rear and right rear doors will not unlock and open with a single pull of the exterior door handle, refer to
Passenger and Rear Door Release Command Inoperative.
瀚慖f a door will not unlock and open with a single pull of the door handle, refer to Passenger or Rear Door Latch Malfunction.
Circuit/System Testing
Driver Door Latch Malfunction
1. Ignition OFF, disconnect the X2 harness connector at the K84 keyless entry control module.
2. Test for less than 10 ohm between the ground circuit terminal 6 and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition OFF, connect the X2 harness connector and disconnect the X4 harness connector at the K84 keyless entry control module.
4. Test for infinite resistance between the control circuit terminal 3 and ground.
