2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2443
DTC Descriptor
DTC P1682
- Ignition 1 Switch Circuit 2
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
There are 2 ignition voltage circuits supplied to the engine control module (ECM). The first ignition circuit is provided by the powertrain relay,
through a fuse. This ignition voltage circuit supplies power to all the internal ECM circuits associated with the throttle actuator control (TAC)
operation. The second ignition voltage circuit is supplied by the run/crank relay through a fuse, and is used to power the remaining internal ECM
circuits. If the ECM detects a voltage difference between the 2 ignition voltage circuits, DTC P1682 will set.
Conditions for Running the DTC
* The ignition is ON.
* System voltage is more than 7 V.
* The powertrain relay is commanded ON.
* DTC P1682 runs continuously when the above conditions are met.
Conditions for Setting the DTC
The ECM detects that the voltage level difference is greater than 3 V between the 2 ignition 1 voltage circuits for less than 1 s.
Action Taken When the DTC Sets
DTC P1682 is a Type A DTC.
Conditions for Clearing the DTC
DTC P1682 is a Type A DTC.
Diagnostic Aids
This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test (See:
Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).
Reference Information
Schematic Reference
* Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Power Distribution Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
