2010 Cadillac Truck Escalade RWD V8-6.2L Page 2852
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information
Bus/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Circuit/System Verification
Verify that DTC B137A is not set in the SDG module.
If the DTC is set, refer to DTC B137A (See: B Code Charts/B137A).
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming
U1814
DTC U1814
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC U1814 00
- Powertrain High Speed Communication Enable Circuit
Diagnostic Fault Information
Circuit/System Description
The accessory wake up serial data circuit is a positive voltage signal to wake up multiple control modules. The signal is activated in 2 ways; any
time the ignition switch is in the ACC or RUN position, or anytime the body control module (BCM) determines that communication is needed from
the powertrain. When the ignition switch is in the ACC or RUN position, the accessory voltage circuit input to the BCM is internally connected to
the accessory wake up serial data circuit output, and voltage is supplied to the modules. The BCM also supplies voltage to the accessory wake up
serial data circuit when it determines that communication is necessary with the powertrain and the ignition is not in the ACC or RUN position such
as during remote start.
Modules activated by the accessory wakeup serial data circuit are as follows:
* Engine control module (ECM)
* Transmission control module (TCM)
* Transfer case control module (TCCM) (RPO NP8)
* Serial data gateway module (SDGM) (RPO HP2)
Conditions for Running the DTC
