DTC P0C53
- Drive Motor 1 Position Sensor Circuit 1 High Voltage
DTC P0C5C
- Drive Motor 1 Position Sensor Circuit 2 Low Voltage
DTC P0C5D
- Drive Motor 1 Position Sensor Circuit 2 High Voltage
Diagnostic Fault Information
Circuit/System Description
The drive motor generator position sensor is monitored by the motor control module (MCM). The MCM monitors the angular position, speed and
direction of the drive motor generator based upon the signals of the resolver-type position sensor. The position sensor, or resolver, contains a drive
coil, two driven coils and an irregular shaped metallic rotor. The metallic rotor is mechanically attached to the shaft of the drive motor generator. At
ignition ON, the MCM outputs a 7 volt ac, 10 kHz excitation signal to the drive coil. The drive coil excitation signal creates a magnetic field
surrounding the two driven coils and the irregular shaped rotor. The MCM then monitors the two driven coil circuits for a return signal. The
position of the irregular shaped metallic rotor causes the magnetically-induced return signals of the driven coils to vary in size and shape. A
comparison of the two driven coil signals allows the MCM to determine the exact position, speed and direction of the drive motor generator.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
P0C52, P0C5D
Circuit voltage less than 0.5 volts.
P0C53, P0C5C
Circuit voltage greater than 3.0 volts.
Action Taken When the DTC Sets
* DTCs P0C52, P0C53, P0C5C and P0C5D are Type A DTCs.
* The hybrid powertrain control module (HPCM) commands the battery energy control module (BECM) to open the high voltage contactor
relays.
Conditions for Clearing the DTC
