2010 Cadillac Truck Escalade AWD V8-6.2L Page 986
Circuit/System Description
The electronic suspension control (ESC) module supplies a 5 volt reference signal to each suspension position sensor. The suspension position
sensors supply an voltage signal of 0.35-4.75 volts to the ESC module which represents the position between the body and the wheel. The sensors
are also grounded through the ESC module.
Conditions for Running the DTC
* Battery voltage is between 9-16 volts
* Ignition is ON
Conditions for Setting the DTC
* The DTC is set when the ESC module measures a position sensor signal voltage below 0.35 volt or above 4.75 volts for more than 1 second
while the vehicle is operated under normal driving conditions.
* The fault is detected during 3 consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with a scan tool.
Action Taken When the DTC Sets
* The ESC will enter the speed dependent damping mode.
* Both left and right normal force outputs will be set to the default output states.
* The ESC sends a message to the instrument panel cluster (IPC) to display SERVICE SUSPENSION SYSTEM message.
Conditions for Clearing the DTC
A history DTC will clear after 50 consecutive ignition cycles if the condition for the malfunction is no longer present.
Reference Information
Schematic Reference
Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Diagrams/Electrical Diagrams/Electronic Suspension Control)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Electronic Suspension Control Description and Operation (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Description and Operation/Electronic Suspension Control Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information
Circuit/System Verification
Ignition ON, observe the scan tool Position Sensor Data parameters. The readings should vary between 0.35-4.75 volts while the vehicle is jounced.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the applicable suspension position sensor.
2. Ignition OFF, test for less than 5 ohm between the low reference circuit terminal C and ground.
锟斤拷If greater than the specified range, test the low reference circuit for an open/high resistance. If circuit tests normal, replace the ESC
module.
3. Ignition ON, test for 4.75-5.25 volts between the 5 volt reference circuit terminal A and ground.
锟斤拷If less than the specified range, test the 5 volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,
