Circuit/System Verification
Verify that DTC P0A1F, P1A01, P1A05, or P1A06 is not set.
If any of the DTCs are set, replace the drive motor generator battery control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.
Control Module References (See: Testing and Inspection/Programming and Relearning) for drive motor generator battery control module
replacement, setup and programming
P0A02
DTC P0A01-P0A03
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0A01
- Motor Electronics Temperature Sensor Circuit Range/Performance
DTC P0A02
- Motor Electronics Temperature Sensor Circuit Low
DTC P0A03
- Motor Electronics Temperature Sensor Circuit High
Diagnostic Fault Information
Circuit/System Description
The generator control module temperature sensor is a variable resistor that measures the temperature of the coolant entering the generator control
module coolant radiator. The engine control module (ECM) supplies 5 V to the generator control module temperature signal circuit, and a ground
for the generator control module temperature low reference circuit.
Conditions for Running the DTC
P0A01
* DTCs P0112, P0113, P0117, P0118, P0101, P0102, P0103, P0A02, P0A03 and P2610 are not set.
* The ignition has been OFF for greater than 8 hours.
* The temperature difference between the intake air temperature and engine coolant temperature sensors is less than or equal to 16锟斤拷C (60.8锟斤拷F)
at ignition ON.
P0A02
* DTCs P0112 or P0113 are not set.
* The engine is running for greater than 10 seconds.
* The intake air temperature is greater than 70锟斤拷C (158锟斤拷F).
* This DTC runs continuously when the above conditions are met.
P0A03
* DTCs P0112 or P0113 are not set.
* The engine is running for greater than 10 seconds.
