P0AAF and P0AB4
The hybrid battery pack air temperature sensor 1 or 2 is less than -40锟斤拷C (-40锟斤拷F).
P0AAE and P0AB3
The hybrid battery pack air temperature sensor 1 or 2 is greater than 95锟斤拷C (203锟斤拷F).
P0AAD
The hybrid battery cooling fan is ON and the difference between sensor 1 and 2 is greater than 10锟斤拷C (50锟斤拷F) difference for 9 seconds.
P0AB2
The hybrid battery cooling fan is ON and the outlet air temperature is greater than maximum hybrid battery temperature value by 10锟斤拷C (50锟斤拷F) for 9
seconds.
Action Taken When the DTC Sets
* DTCs P0AAD, P0AAE, P0AAF, P0AB2, P0AB3, and P0AB4 are type B DTCs.
* The drive motor generator battery sends a message to the hybrid powertrain control module to reduce the power by 50 percent.
Conditions for Clearing the DTC
DTCs P0AAD, P0AAE, P0AAF, P0AB2, P0AB3, and P0AB4 are type B DTCs.
Reference Information
Schematic Reference
Hybrid Cooling Schematics ()
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Drive Motor Generator Battery Cooling Description ()
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Special Tools
EL-48900 HEV Safety Kit
Circuit/System Verification
1. Verify that DTC P0A80, P0A81 or P0BBD is not set.
锟斤拷If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).
2. Ignition ON, using a scan tool, command the hybrid battery pack fan speed to 60 percent and let it run for 2 minutes.
3. Observe the scan tool hybrid battery air inlet and outlet temperature parameters. The readings should be between -39 and +95锟斤拷C (-38.2 and
+203锟斤拷F) with no greater than a 10锟斤拷C ( 50锟斤拷F) difference. Refer to Temperature Versus Resistance ().
