2010 Cadillac Truck Escalade AWD V8-6.2L Page 999
4. Test for 4.8-5.2 V between the 5 V reference circuit terminal 1 and the signal circuit terminal 6.
锟斤拷If not within the specified range, test the signal circuit for short to voltage or an open/high resistance. If the circuit tests normal, replace
the EBCM.
5. Ignition OFF, disconnect the harness connector at the EBCM.
6. Test for infinite resistance between the signal circuit terminal 9 and ground.
锟斤拷If not the specified value, test the signal circuit for a short to ground.
7. Connect the harness connector at the EBCM.
Note: When measuring voltage, the voltage values are based on a battery charge of 12.5 V and the steering wheel is in the center position.
8. Ignition ON, at the steering angle sensor connector harness, test for 6.8-11 V between the signal circuit terminals listed below and ground.
* Phase A terminal 3
* Phase B terminal 4
* Phase C terminal 5
锟斤拷If less than the specified range, test the appropriate signal circuit for a short to ground or an open/high resistance. If the circuit tests
normal, replace the EBCM.
锟斤拷If greater than the specified range, test the appropriate signal circuit for a short to voltage. If the circuit tests normal, replace the EBCM.
9. If the circuits test normal, replace the steering angle sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Steering Wheel Position Sensor Replacement (See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and
Switches - Steering/Steering Angle Sensor/Service and Repair/Steering Wheel Position Sensor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming
C0711
DTC C0711
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0711 00
- Level Control Air Pressure Sensor Malfunction Signal Invalid
Diagnostic Fault Information
Circuit Description
The automatic level control (ALC) pressure sensor sends a voltage signal to the electronic suspension control module (ESCM) that corresponds to a
pressure within the range of 30-180 psi.
Conditions for Running the DTC
