3. Disconnect transmission X176 connector and inspect for the following:
* Proper terminal contact
* Proper terminal retention in the connector
* Foreign material or moisture
锟斤拷Repair, replace or clean the connector as appropriate.
4. Reconnect all connectors and test drive the vehicle.
锟斤拷If the DTC sets, replace the applicable drive motor generator and retest for DTCs. If the DTC sets, replace the PIM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup and programming
* Drive Motor with Generator Assembly Removal - 2nd Position (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Service and Repair/Overhaul/2ML70 - Automatic Transmission/13. Drive Motor with Generator Assembly Removal
- 2nd Position)
* Transmission Control Wiring Harness Extension Harness Removal (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Service and Repair/Overhaul/2ML70 - Automatic Transmission/5. Transmission Control Wiring Harness Extension
Harness Removal)
P0C58
DTC P0C57, P0C58, P0C61, or P0C62
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0C57
- Drive Motor 2 Position Sensor Circuit 1 Low Voltage
