- Drive Motor 1 Phase U-V-W Circuit
Circuit/System Description
Each drive motor generator is controlled by a motor control module (MCM). The drive motor generators utilize 3 phase alternating current (ac)
electricity. The drive motor generator stator coil is comprised of three phase circuits. The phase circuits are identified as phase U, phase V and
phase W. The U-V-W phase circuits are connected in a wye configuration. This means each phase is connected at a single, central point. The MCM
monitors a current sensor connected to each drive motor generator phase.
Conditions for Running the DTC
* The Hybrid Wakeup circuit is active.
* The MCM has applied current to the drive motor generator.
Conditions for Setting the DTC
The MCM detects at least one U-V-W phase current sensor is less than 9 amps.
Action Taken When the DTC Sets
* DTC P0C05 is a Type A DTC.
* The hybrid powertrain control module (HPCM) commands the battery energy control module (BECM) to open the high voltage contactor
relays.
Conditions for Clearing the DTC
DTC P0C05 is a Type A DTC.
Reference Information
Schematic Reference
Hybrid Controls Schematics ()
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Clear the DTC information.
2. Turn the ignition OFF for 1 minute.
3. Attempt to start the engine.
4. Retest for DTC P0C05.
Circuit/System Testing
Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection.
Personal Protection Equipment (PPE) and proper procedures must be followed.
The High Voltage Disabling procedure will perform the following tasks:
* Identify how to disable high voltage.
* Identify how to test for the presence of high voltage.
* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures
must be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.
