Wednesday, November 27, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1068

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1068



瀚慖f warmer than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K20 ECM.



Note: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.



6. Ignition ON, install a 3 A fused jumper wire between the signal circuit terminal 1 and the low reference circuit terminal 2. Verify the ECT



sensor parameter is greater than 142掳C (288掳F).



瀚慖f less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace



the K20 ECM.



7. If all circuits test normal, test or replace the B34 ECT sensor.



Component Testing



1. Ignition OFF, disconnect the harness connector at the B34 engine coolant temperature (ECT) sensor.



Note: A thermometer can be used to test the sensor off the vehicle.



2. Test the ECT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature



Versus Resistance - Engine Coolant Temperature Sensor (See: Powertrain Management/Computers and Control



Systems/Specifications/Temperature Versus Resistance - Engine Coolant Temperature Sensor) table and verify that the resistance is within 5



% of the specification.



瀚慖f not within the specified range, replace the B34 ECT sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Engine Coolant Temperature Sensor Replacement (LF1) (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature



Sensor/Switch/Coolant Temperature Sensor/Switch (For Computer)/Service and Repair)Engine Coolant Temperature Sensor Replacement



(LAU) (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature Sensor/Switch/Coolant Temperature



Sensor/Switch (For Computer)/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



P0117



DTC P0117 or P0118 (LAU)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0117



- Engine Coolant Temperature (ECT) Sensor Circuit Low Voltage



DTC P0118



- Engine Coolant Temperature (ECT) Sensor Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data