2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2972
* The system voltage is between 9-16 volts.
* The vehicle power mode master requires serial data communication to occur from this specific module.
Conditions for Setting the DTC
A supervised periodic message that includes the transmitter module availability has not been received.
Action Taken When the DTC Sets
The modules is never signaled, therefore the specific subsystems will not function.
Conditions for Clearing the DTC
* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
Diagnostic Aids
* When testing circuits to the SDGM access can be accomplished by removing the instrument panel center trim panel. Note that this procedure
does not allow removal of the SDGM, only access to the connector. Refer to Instrument Panel Center Trim Panel Replacement (Cadillac) (
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Trim Panel
Replacement (Cadillac))Instrument Panel Center Trim Panel Replacement (Except Cadillac) (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Trim Panel Replacement (Except Cadillac)).
* DTC U1816 can set current in the HPCM, ECM, and the SDGM.
* If DTC U1816 is only set in the HPCM, the PIM must be replaced due to all circuits between the HPCM and MCM being internal to the PIM.
Reference Information
Schematic Reference
* Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical
Diagrams)
* Control Module References (See: Testing and Inspection/Programming and Relearning)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information
Bus/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Circuit/System Verification
1. Verify that DTC B137A is not current in the serial data gateway module (SDGM).
瀚慖f the DTC is current in the SDGM, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).
2. Verify that DTC U1816 is not set current only in the HPCM.
瀚慖f the DTC is current in the HPCM only, replace the drive motor power inverter module (PIM).
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector X1 at the PIM.
2. Test for less than 5 ohms between the PIM case and ground.
瀚慖f greater than the specified range, test the ground strap for an open/high resistance. If the circuit tests normal, replace the PIM.
