2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 632
Circuit/System Description
The Bluetooth (R) antenna is a small fixed antenna connected directly to the communication interface module (CIM) and is used to send and
receive signals from a Bluetooth (R) enabled cellular phone. The antenna utilizes no cabling and is not external to the vehicle.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage must be between 9-16 V.
* The CIM tests the antenna once every second.
Conditions for Setting the DTC
B2485 02
The CIM detects a short to ground in the Bluetooth (R) antenna.
B2485 04
The CIM detects an open/high resistance in the Bluetooth (R) antenna.
Actions Taken When the DTC Sets
* The OnStar (R) status LED turns red.
* Bluetooth (R) functionality is disabled.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.
Schematic Reference
OnStar Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/OnStar Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
OnStar Description and Operation (See: Accessories and Optional Equipment/Description and Operation/OnStar Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Verify the Bluetooth (R) antenna is properly connected to the CIM and is not damaged.
锟斤拷If the antenna is disconnected or damaged, repair or replace as necessary.
2. Ignition ON, verify the DTC B2485 is not set.
锟斤拷If the DTC is set, replace the Bluetooth (R) antenna. Clear the DTC and cycle the ignition OFF then back ON. If the DTC resets as
current, replace the CIM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
