Friday, November 1, 2019

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 594

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 594

Important: Element resistance must be measured twice to ensure that all failure conditions are simulated. First with the seat

unoccupied, then with the seat occupied.

2. Test for 2.0 - 8.0 Ohms between control circuit terminal 6 and control circuit terminal 2.

锟斤拷If less than the specified range, test for a short between the control circuits. If the circuits test normal, replace the seat cushion heater

element.

锟斤拷If greater than the specified range, test the control circuits for an open/high resistance. If the circuits test normal, replace the seat cushion

heater element.

3. Disconnect the X2, X4 harness connectors at the HSM.

4. Test for 850 Ohms - 300 kOhms between the signal circuit terminal 20 X4 and the low reference circuit terminal 8 X2.

锟斤拷If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat

cushion heater element/temperature sensor.

锟斤拷If greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits

test normal, replace the seat cushion heater element/temperature sensor.

5. Connect the X1, X2, X4 harness connectors at the HSM.

6. Disconnect the harness connector at the seat cushion heater element/temperature sensor.

7. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.

锟斤拷If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the HSM.

锟斤拷If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the HSM.

8. If all circuits test normal, replace the HSM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Driver or Passenger Seat Cushion Heater Replacement (without HP2) ()Driver or Passenger Seat Cushion Heater Replacement (with HP2)

()

* Control Module References (See: Testing and Inspection/Programming and Relearning) for the HSM replacement, setup, and programming

Rear Seat

DTC B2425 or B2430 (Rear Seat)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B2425 04

- Left Seat Heater Cushion Circuit Open

DTC B2425 0A

- Left Seat Heater Cushion Circuit Rate of Change Below Threshold

DTC B2425 0B

- Left Seat Heater Cushion Circuit Current Above Threshold

DTC B2425 0C

- Left Seat Heater Cushion Circuit Current Below Threshold

DTC B2425 0D

- Left Seat Heater Cushion Circuit Resistance Above Threshold

DTC B2425 0E

- Left Seat Heater Cushion Circuit Resistance Below Threshold