2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 627
The internal backlighting of the navigation display screen located in the navigation radio.
Conditions for Running the DTC
* Radio ON.
* Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
* The navigation radio tests the navigation display backlighting every 1 second.
* The radio determines there is a malfunction or overheat condition in the navigation display backlighting.
Action Taken When the DTC Sets
Navigation backlighting may be too bright, dim or blank.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.
Diagnostic Aids
Occasionally it is possible to overheat the navigation display backlighting due to excessive ambient heat inside the vehicle. In this instance it may
be necessary to allow time for the display to cool.
Reference Information
Schematic Reference
Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Navigation System Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Navigation System
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition OFF, allow the navigation display to cool if the ambient temperature inside the vehicle is excessive and the radio is hot to the touch.
Verify the navigation display is cool and the DTC has cleared and gone to history.
2. Ignition ON, with a scan tool, clear all DTCs and operate the audio/navigation system within the Conditions for Running the DTC. Verify the
DTC does not reset.
锟斤拷If the DTC resets, replace the radio.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for Radio replacement, setup, and programming
