2010 Cadillac Truck Escalade AWD V8-6.2L Page 199
module may cause inaccurate resistance readings.
3. Ignition OFF, remove the AIR BAG BATT Fuse. Test for less than 2.0 ohms between low reference terminal C and ground.
锟斤拷If greater than the specified range, test the low reference circuit for open/high resistance. If the circuit tests normal, replace the PPS.
4. Ignition OFF, disconnect the harness connector at the PPS module.
5. Test for infinite resistance between the signal circuit terminal B and ground.
锟斤拷If less than the specified value, test the signal circuit for a short to ground.
6. Ignition ON, test for less than 1 volt between the signal circuit terminal B and ground.
锟斤拷If greater than the specified range, test the signal circuit for a short to voltage.
7. Test for less than 1 ohm between the PPS sensor signal circuit terminal B and the PPS module terminal 6.
锟斤拷If greater than the specified range, test the signal circuit for open/high resistance. If the circuit tests normal, replace the PPS.
8. If all circuits test normal, replace the PPS which includes the pressure sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for PPS replacement, setup, and programming
B0079
DTC B0079 or B0080
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category
DTC Descriptors
DTC B0079 01
- Driver Seat Position Sensor Circuit Short to Battery
DTC B0079 02
- Driver Seat Position Sensor Circuit Short to Ground
DTC B0079 04
- Driver Seat Position Sensor Circuit Open
DTC B0079 05
- Driver Seat Position Sensor Circuit High Voltage or Open
DTC B0079 06
- Driver Seat Position Sensor Circuit Low Voltage or Open
DTC B0079 08
- Driver Seat Position Sensor Circuit Performance-Signal Invalid
DTC B0079 0C
- Driver Seat Position Sensor Circuit Low Current
DTC B0080 01
- Passenger Seat Position Sensor Circuit Short to Battery
DTC B0080 02
- Passenger Seat Position Sensor Circuit Short to Ground
