锟斤拷 If greater than the specified range, replace the hood ajar switch.
4. With the switch in the hood open position, test for infinite resistance between the ground terminal C and the signal terminal B.
锟斤拷 If not infinite, replace the hood ajar switch.
5. Test for less than 2.0 ohms between the ground terminal C and the signal terminal A.
锟斤拷 If greater than the specified range, replace the hood ajar switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Hood Primary and Secondary Latch Replacement (See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup
B3031
DTC B3031
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3031 00
- Security System Controller In Learn Mode
Circuit/System Description
When learning a coded key, the theft deterrent module (TDM) is placed in learn mode. DTC B3031 will set automatically as an indicator that the
system is in learn mode and not as a fault indicator. Once the coded key is learned, learn mode will be exited and the DTC cleared. If the TDM does
not exit learn mode, B3031 will remain current and indicate a fault.
Conditions for Running the DTC
The immobilizer system is the learn coded keys state.
Conditions for Setting the DTC
DTC B3031 will set any time the TDM enters the learn coded keys state.
Action Taken When the DTC Sets
The security indicator will illuminate.
Conditions for Clearing the DTC
* A current DTC B3031 will be cleared upon the successful exit of learn mode.
* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and
