锟斤拷 If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the object
alarm module.
3. Ignition ON, transmission in REVERSE, test for 8.0-9.0 V between the voltage reference circuit terminal 1 and ground.
锟斤拷 If greater than the specified range, test the voltage reference circuit for a short to voltage. If the circuit tests normal, replace the object
alarm module.
锟斤拷 If less than the specified range, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,
replace the object alarm module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Rear Object Sensor Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Parking Assist
Distance Sensor/Service and Repair/Rear Object Sensor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for object alarm module replacement, setup, and
programming
B0967
DTC B0967
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B0967 02
- Parking Aid Switch Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
The parking assist system can be disabled by pressing the parking assist disable switch. When pressed, the parking assist disable signal circuit is
pulled to ground. When the parking assist system is disabled, the object alarm module will ground the parking assist disable indicator control circuit,
illuminating the indicator.
Conditions for Running the DTC
* DTC B1325 is not set
* Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
The object alarm module has detected that the parking assist disable switch signal circuit is shorted to ground.
Action Taken When the DTC Sets
* The parking assist system is disabled.
* The parking assist disable indicator is not illuminated.
* The object alarm module sends a serial data message to the instrument panel cluster (IPC) to display SERVICE PARK ASSIST message in the
driver information center (DIC).
Conditions for Clearing
