* The current DTC will clear and set the code to history, 3 seconds after no motor movement is requested or the current is no longer
mismatched, and the ignition is cycled OFF then back to ACC or RUN.
* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.
Reference Information
Schematic Reference
* Driver Seat Schematics ()
* Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Memory Seats Description and Operation ()
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
DTC B1335 00 or B1335 0B
1. Ignition ON, use a scan tool to clear the current and history diagnostic trouble code.
2. Determine which motor set this DTC by operating the motors listed below one at a time in both directions. Check for the DTC to set between
each motor test.
* Driver seat front vertical motor
* Driver seat rear vertical motor
* Driver seat horizontal motor
* Driver seat recline motor
* Driver seat lumbar horizontal motor
* Driver seat lumbar vertical motor
* Adjustable pedal motor
3. Clear the diagnostic trouble codes.
4. Ignition OFF, disconnect the X1 harness connector at the appropriate seat adjuster assembly, lumbar adjuster assembly, or the adjustable pedal
motor for which the DTC set.
5. Ignition ON, operate the motor adjuster switch in both directions. DTC B1335 00 or B1335 0B should not set.
锟斤拷 If the DTC sets, test for a short between appropriate motor control circuits listed below. If the circuits test normal, replace the MSM.
* Front vertical motor terminal 2 and terminal 5
* Rear vertical motor terminal 1 and terminal 4
* Seat horizontal motor terminal 3 and terminal 6
* Seat recline motor terminal A and terminal B
* Lumbar vertical motor terminal A and terminal B
* Lumbar horizontal motor terminal C and terminal D
* Adjustable pedal motor terminal 4 and terminal 5
6. Test the appropriate control circuits listed below for a high resistance. If all circuits test normal, test or replace the appropriate seat, lumbar, or
adjustable pedal motor.
* Front vertical motor terminal 2 and terminal 5
* Rear vertical motor terminal 1 and terminal 4
* Seat horizontal motor terminal 3 and terminal 6
* Seat recline motor terminal A and terminal B
* Lumbar vertical motor terminal A and terminal B
