* Front vertical upward switch terminal A
* Front vertical downward switch terminal K
* Rear vertical upward switch terminal F
* Rear vertical downward switch terminal J
* Horizontal forward switch terminal D
* Horizontal rearward switch terminal C
* Recline forward switch terminal H
* Recline rearward switch terminal G
3. If all circuits test normal, test or replace the seat adjuster switch.
Component Testing
1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.
2. Test for infinite resistance between each seat direction signal terminal listed below and the B+ terminal E with the switch in the open position.
* Front vertical upward switch terminal A
* Front vertical downward switch terminal K
* Rear vertical upward switch terminal F
* Rear vertical downward switch terminal J
* Horizontal forward switch terminal D
* Horizontal rearward switch terminal C
* Recline forward switch terminal H
* Recline rearward switch terminal G
锟斤拷 If not the specified value, replace the seat adjuster switch.
3. Test for less than 1 ohm between each seat direction signal terminal listed below and the B+ terminal E with the switch in the closed position.
* Front vertical upward switch terminal A
* Front vertical downward switch terminal K
* Rear vertical upward switch terminal F
* Rear vertical downward switch terminal J
* Horizontal forward switch terminal D
* Horizontal rearward switch terminal C
* Recline forward switch terminal H
* Recline rearward switch terminal G
锟斤拷 If greater than the specified range, replace the adjuster switch switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Power Seat Switch Replacement (with HP2) ()Power Seat Switch Replacement (without HP2) ()
* Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming
B1750
DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1735 01
- Seat Front Up Switch Circuit Short to Battery
DTC B1740 01
- Seat Front Down Switch Circuit Short to Battery
