Thursday, June 6, 2019

2019 Cadillac Truck Escalade AWD V8-6.2L Diagnostic Instructions Page 211


* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. With a master vehicle key, turn the ignition ON.



2. Observe the security indicator. After approximately 10 minutes, the indicator will turn off.



3. Turn the ignition OFF and wait 5 seconds.



4. Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.



5. With a master vehicle key, turn the ignition ON. The start disable will now be cleared.



6. Using the Red Emergency Button, notify the advisor that the Ignition Block on the vehicle has been cleared and to update the account status.



B320A



DTC B320A



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC B320A 39



- Front Door Window Motor Internal Electronic Failure



DTC B320A 42



- Front Door Window Motor Calibration Data Set Not Programmed



DTC B320A 4B



- Front Door Window Motor Calibration Not Learned



Diagnostic Fault Information