Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information
Circuit/System Verification
1. Ignition ON, perform the scan tool Learn Column Soft Stops procedure. Refer to Power Tilt Steering Column Calibration (See: Steering and
Suspension/Steering/Steering Column/Testing and Inspection/Programming and Relearning).
2. Operate the vehicle within the Conditions for Running and Setting. Verify DTC B2890 does not reset.
锟斤拷 If the DTC resets, replace the MSM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming
B3006
DTC B3006
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3006 5A
- Hood Ajar Circuit Plausibility Failure
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) monitors the voltage input of the hood open switch signal circuit and the hood open closed switch signal circuit.
With the hood open, the hood ajar portion of the switch is closed, grounding the hood ajar switch signal circuit from the BCM, and the hood closed
portion of the switch is open. With the hood closed, the hood closed portion of the switch is closed, grounding the hood closed switch signal circuit
from the BCM, and the hood ajar portion of the switch is open. During proper operation, the two separate voltage signals at the BCM should never
be at the same voltage.
Conditions for Running the DTC
The BCM continuously monitors for this DTC
Conditions for Setting the DTC
Both the hood open switch signal circuit and the hood closed switch signal circuit are simultaneously in an active or inactive state.
Action Taken When the DTC Sets
* Remote start functions will be disabled.
* The hood ajar switch inputs will be ignored by content theft deterrent (CTD).
Conditions for Clearing the DTC
* A current DTC will clear when the conditions for setting are no longer present.
* A history DTC will clear after 40 malfunction free ignition cycles.
