Circuit/System Description
The adjustable pedals forward and rearward switches are inputs to the memory seat module (MSM). The MSM supplies the switch assembly with a
battery positive reference voltage. When the switch is operated to the forward or rearward direction, battery positive voltage is applied to the forward
or rearward switch signal inputs.
Conditions for Running the DTC
System voltage is 9-16 volts.
Conditions for Setting the DTC
The forward and rearward switch signal circuits are active at the same time.
Action Taken When the DTC Sets
The adjustable pedals will be disabled.
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 100 malfunction-free ignition cycles.
Reference Information
Schematic Reference
Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Adjustable Pedals Description and Operation (with Memory) (See: Accessories and Optional Equipment/Pedal Positioning System/Description and
Operation/Adjustable Pedals Description and Operation (with Memory))Adjustable Pedals Description and Operation (w/o Memory) (See:
Accessories and Optional Equipment/Pedal Positioning System/Description and Operation/Adjustable Pedals Description and Operation (w/o
Memory))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Pedal Forward Switch and Pedal Aft Switch parameters while cycling the adjustable pedal switch between the
FWD and RWD position. The appropriate parameter should change between Active and Inactive as commanded.
Circuit/System Testing
1. Disconnect the harness connector at the adjustable pedal switch.
