DTC B1449 07
- Remote Device Voltage Above Threshold
Diagnostic Fault Information
Circuit/System Description
The infrared module is supplied with 10.5 volts from the rear audio/HVAC module when the rear audio system is active. The infrared module is
permanently grounded at G300.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
The DTC will set when the rear audio/HVAC module detects a short to voltage, short to ground, or an open/high resistance in the infrared module
voltage signal circuit.
Action Taken When the DTC Sets
The rear audio/HVAC module sets the DTC and the infrared module will be disabled.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Video Entertainment System Description and Operation (Non-Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and
Operation/Video Entertainment System Description and Operation (Non-Headrest DVD Systems))Video Entertainment System Description and
Operation (Dual Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and Operation/Video Entertainment System
Description and Operation (Dual Headrest DVD Systems))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the infrared module.
2. Ignition OFF, test for less than 5.0 ohms between the ground circuit terminal 12 and ground.
锟斤拷 If greater than the specified range, test the ground circuit for an open/high resistance.
