Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the rear video display.
2. Ignition ON, test for 100-300 Hz at the control circuit terminal 9.
锟斤拷 If not within the specified range, test the control circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests
normal, replace the radio.
3. If all circuits test normal, replace the rear video display.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Video Display Replacement (Second Row) (See: Accessories and Optional Equipment/Entertainment Systems/Television / Monitor/Service
and Repair/Video Display Replacement (Second Row))Video Display Replacement (Third Row) (See: Accessories and Optional
Equipment/Entertainment Systems/Television / Monitor/Service and Repair/Video Display Replacement (Third Row))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for Radio replacement, setup, and programming
B1325
DTC B1325
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1325 03
- Device Power Circuit Voltage Below Threshold
DTC B1325 07
- Device Power Circuit Voltage Above Threshold
Diagnostic Fault Information
Circuit/System Description
The control modules on this vehicle monitor the voltage on the battery positive (B+) voltage circuits. The following modules on this vehicle will set
DTC B1325 if high or low battery voltage is detected:
* Audio amplifier
* Instrument panel cluster (IPC)
* Passenger presence system (PPS)
* Radio
* Rear object sensor control module
Conditions for Running the DTC
* The ignition is ON.
* The ignition switch has not been in the start position for 2 seconds.
Conditions for Setting the DTC
