2010 Cadillac CTS Sedan AWD V6-3.6L Page 1379
Note: The ignition circuit supplies voltage to other components. Make sure you test all circuits for a short to ground or test all components
for being shorted that share the ignition circuit.
2. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit terminal D and ground.
瀚慖f the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal and the
ignition circuit fuse is open, test all the components connected to the ignition voltage circuit and replace as necessary.
3. Crank or start the engine. Test for 200-400 mV between the appropriate IC circuit terminal C and ground.
瀚慖f less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit/connection tests normal,
replace the K20 ECM.
瀚慖f greater than the specified range, test the circuit for a short to voltage. If the circuit/connection tests normal, replace the K20 ECM.
4. Connect a test lamp between the each of the ground circuits terminal A, and terminal B, and B+. The test lamp should illuminate on each
circuit.
瀚慖f the test lamp does not illuminate, test the suspected circuit for an open/high resistance.
5. If all circuits/connections test normal, replace the T8 ignition coil.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Ignition Coil Replacement - Bank 1 (See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Ignition Coil
Replacement - Bank 1)
* Ignition Coil Replacement - Bank 2 (See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair/Ignition Coil
Replacement - Bank 2)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0365
DTC P0340, P0345, P0365, or P0390 (w/LF1)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0340
- Intake Camshaft Position Sensor Circuit Bank 1
DTC P0345
- Intake Camshaft Position Sensor Circuit Bank 2
DTC P0365
- Exhaust Camshaft Position Sensor Circuit Bank 1
DTC P0390
- Exhaust Camshaft Position Sensor Circuit Bank 2
Diagnostic Fault Information
