2010 Cadillac Truck SRX FWD V6-3.0L Page 1892
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC P1682
- Ignition 1 Switch Circuit 2
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
There are 2 ignition voltage circuits supplied to the engine control module (ECM). The first ignition circuit is provided by the engine controls
ignition relay, or powertrain relay, through a fuse. This ignition voltage circuit supplies power to all the internal ECM circuits associated with the
throttle actuator control (TAC) operation. The second ignition voltage circuit is supplied by the run/crank relay through a fuse, and is used to power
the remaining internal ECM circuits. If the ECM detects a voltage difference between the 2 ignition voltage circuits, DTC P1682 will set.
Conditions for Running the DTC
* The ignition is ON.
* System voltage is more than 6 V.
* The powertrain relay is commanded ON.
* DTC P1682 runs continuously.
Conditions for Setting the DTC
The ECM detects that the voltage level difference is greater than 3 V between the 2 ignition voltage circuits for less than 1 s.
Action Taken When the DTC Sets
DTC P1682 is a Type A DTC.
Conditions for Clearing the DTC
DTC P1682 is a Type A DTC.
Reference Information
Schematic Reference
* Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls
Schematics (LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Power Distribution Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Electrical Information Reference
