2010 Cadillac Truck SRX FWD V6-3.0L Page 1680
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Perform the Transmission Fluid Level and Condition Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing
and Inspection/Symptom Related Diagnostic Procedures/AF40-6 - Automatic Transmission/Transmission Fluid Level and Condition Check)
to verify correct fluid level.
2. Engine idling at operating temperature, observe the scan tool Transmission Fluid Temperature parameter. The reading should be between -40
to +215掳C (-40 to +488掳F) and change.
3. Operate the vehicle at about 60 km/h (37 MPH) for 10 min. Verify the scan tool Transmission Fluid Temperature parameter varies by more
than 2掳C (3.5掳F) to verify that the sensor is not stuck.
Circuit/System Testing
Operate the vehicle within the conditions for running and setting the DTC to verify the DTC does not reset. You may also operate the vehicle
within the conditions that you observed from the Freeze Frame/Failure Records data.
Component Testing
Static Test
1. Ignition OFF, remove the K71 Transmission Control Module.
2. Ignition OFF, test for infinite resistance between the low reference circuit terminal 7 X2 and ground.
瀚慖f less than the specified range, replace the wiring harness.
3. Ignition OFF, test for infinite resistance between the signal circuit terminal 8 X2 and ground.
瀚慖f less than the specified range, replace the wiring harness.
4. Test for infinite resistance between each terminal and the low reference circuit terminal 7 X2 and also to the signal circuit terminal 8 X2.
瀚慖f less than the specified range, replace the wiring harness.
5. Test for the resistance between the B13 Automatic Transmission Fluid Temperature Sensor signal circuit terminal 7 X2 and the low reference
circuit terminal 8 X2. Refer to Transmission Fluid Temperature Sensor Specifications (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Specifications/Pressure, Vacuum and Temperature Specifications) for the resistance values.
瀚慖f not within the specified range, replace the wiring harness.
6. If the circuit test normal, replace the K71 Transmission Control Module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Wiring Harness/Service and Repair) for replacement.
* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup, and
programming.
* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).
P0716
DTC P0716 or P0717
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
