2010 Cadillac CTS Sedan AWD V6-3.6L Page 611
Diagnostic Fault Information
Circuit/System Description
When the content theft deterrent (CTD) system arms and the inclination and intrusion sensors are enabled, the body control module (BCM) receives
a power-up acknowledgement from the sensors via the sensor signal circuit.
Conditions for Running the DTC
* The inclination and intrusion sensors are enabled
* The CTD system has armed
Conditions for Setting the DTC
The BCM does not receive the power-up acknowledgement from the inclination and intrusion sensors
Action Taken When the DTC Sets
The BCM will ignore all inputs from the inclination and intrusion sensors for the remainder of the CTD system arming cycle
Conditions for Clearing the DTC
A current DTC will clear when the BCM receives a power-up acknowledgement during the next CTD system arming cycle
Reference Information
Schematic Reference
Theft Deterrent System Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Theft
Deterrent System Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Content Theft Deterrent (CTD) Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description
and Operation/Content Theft Deterrent (CTD) Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
Scan Tool Reference
Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the inclination sensor.
2. Verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
3. Disconnect the harness connector at the intrusion sensor.
4. Verify a test lamp illuminates between the B+ circuit terminal A and ground.
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
5. Ignition OFF, disconnect the harness connector at the intrusion sensor.
6. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal A and ground.
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
