Saturday, March 13, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 500

2010 Cadillac CTS Sedan AWD V6-3.6L Page 500



* Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming



B2530



DTC B2530



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B2530 00



- Front Fog Lamps Control Circuit



Diagnostic Fault Information



Circuit/System Description



The front fog lamp relay is supplied with battery voltage at all times. The front fog lamp switch signal circuit is grounded momentarily by pressing



the front fog lamp switch. The body control module (BCM) energizes the front fog lamp relay by applying ground to the front fog lamp relay



control circuit. When the front fog lamp relay is energized, the relay switch contacts close and battery voltage is applied through the FRT FOG fuse



to the front fog lamp supply voltage circuit which illuminates the front fog lamps.



Conditions for Running the DTC



* Battery voltage must be between 9-16 V.



* Front fog lamps ON.



Conditions for Setting the DTC



The BCM detects a short to voltage in the front fog lamp relay control circuit for 5 seconds or greater.



Actions Taken When the DTC Sets



The front fog lamps will not operate when the park lamps are ON and the front fog lamp switch is active.



Conditions for Clearing the DTC



* The condition responsible for setting the DTC no longer exists.



* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.



Reference Information



Schematic Reference



Fog Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Fog Lights Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems Description