2010 Cadillac Truck Escalade RWD V8-6.2L Page 2573
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6L45/6L50/6L80/6L90 - Automatic
Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).
3. Place the Q8 control solenoid valve assembly on a clean work surface near the transmission assembly.
4. Connect DT-47825-10 - jumper harness between the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly
electrical connector.
5. Ignition ON, verify with a scan tool the following test status parameters display OK:
* Pressure Control Solenoid Valve 5 Performance Test Status
* Pressure Control Solenoid Valve 5 Control Circuit High Voltage Test Status
* Pressure Control Solenoid Valve 5 Control Circuit Low Voltage Test Status
瀚慖f any test status parameter displays Fault or Malfunction, replace the Q8 control solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Programming and Relearning) following all transmission related repairs.
* Replace the control solenoid valve assembly. Refer to Control Module References (See: Testing and Inspection/Programming and
Relearning) for replacement, setup, and programming.
2ML70 - Automatic Transmission
DTC P2728-P2730
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P2728
- Pressure Control (PC) Solenoid 5 System Performance
DTC P2729
- Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage
DTC P2730
- Pressure Control (PC) Solenoid 5 Control Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The clutch pressure control solenoid 5 is part of the control solenoid valve assembly and is not serviced separately. The transmission control
module supplies 12 volts to the PC solenoid 5 through the high side driver 1 circuit. The transmission control module controls the clutch pressure
control solenoid 5 through the clutch pressure control solenoid 5 control circuit. The normally low clutch pressure control solenoid 5 flows fluid to
the actuator feed limit valve when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 5 regulates the
transmission fluid pressure from the auxiliary transmission fluid pump in order to maintain transmission fluid pressure during electric only and
auto-stop modes.
Conditions for Running the DTC
