2010 Cadillac CTS Sedan AWD V6-3.6L Page 211
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. With a master vehicle key, turn the ignition ON.
2. Observe the security indicator. After approximately 10 minutes, the indicator will turn off.
3. Turn the ignition OFF and wait 5 seconds.
4. Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.
5. With a master vehicle key, turn the ignition ON. The start disable will now be cleared.
6. Using the Red Emergency Button, notify the OnStar advisor that the Ignition Block on the vehicle has been cleared and to update the account
status.
B320A
DTC B320A
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B320A 39
- Front Door Window Motor Internal Electronic Failure
DTC B320A 42
- Front Door Window Motor Calibration Data Set Not Programmed
DTC B320A 4B
- Front Door Window Motor Calibration Not Learned
Diagnostic Fault Information
