2010 Cadillac Truck SRX AWD V6-3.0L Page 512
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Heated/Vented Seat Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Heated/Vented
Seat)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate E14F or E14H rear seat cushion heating element.
2. Test for less than 10 Ohms between the low reference circuit terminal D and ground.
瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit test normal, replace the K29R
rear seat heating control module.
3. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K29R rear seat heating control module.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K29R rear seat
heating control module.
4. If all circuits test normal, test or replace the E14 rear seat cushion heating element.
Component Testing
E14F or E14H Seat Cushion Heating Element
1. Ignition OFF, disconnect the harness connector at the appropriate E14F or E14H rear seat cushion heating element.
2. Test for 500 Ohms - 300 kOhms between the signal circuit terminal C and the low reference circuit terminal D.
瀚慖f not within the specified range, replace the E14 rear seat cushion heating element.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Rear Seat Cushion Heater Replacement (40 Percent Seat) (See: Body and Frame/Seats/Seat Temperature Element/Service and Repair/Rear
Seat Cushion Heater Replacement (40 Percent Seat))Rear Seat Cushion Heater Replacement (60 Percent Seat) (See: Body and
Frame/Seats/Seat Temperature Element/Service and Repair/Rear Seat Cushion Heater Replacement (60 Percent Seat))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for rear seat heating control module replacement,
setup, and programming
With Memory A45
DTC B1925 or B2170 (With Memory A45)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
