2010 Cadillac CTS Sedan AWD V6-3.6L Page 203
* Component locations on the back lighting dimming control circuit.
* Each components control and ground circuit terminals.
1. Ignition OFF, disconnect the harness connector at any component with inoperative backlighting.
2. Ignition OFF, scan tool disconnected, interior lamps OFF, doors CLOSED, test for less than 5 ohm between the ground circuit and ground.
瀚慖f greater than the specified value, test the ground circuit for an open/high resistance.
3. Connect a test lamp between the control circuit and ground.
4. Command the Incandescent Dimming control ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between
the commanded states.
瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the BCM.
瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
5. If all circuits test normal, test or replace the component with the inoperative backlighting.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Refer to the appropriate replacement procedure for the component causing the condition.
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
B0268
DTC B0248, B0268, B0408, B0413, B0418, B0423, B3761, or B3773
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of the diagnostic category.
DTC Descriptors
DTC B0248 61
- Air Flow Control 3 Circuit Actuator Stuck
DTC B0268 61
- Air Flow Control 7 Circuit Actuator Stuck
DTC B0408 61
- Temperature Control 1 Circuit Actuator Stuck
DTC B0413 06
- Temperature Control 1 Feedback Circuit Short to Ground or Open
DTC B0418 61
- Temperature Control 2 Circuit Actuator Stuck
DTC B0423 06
- Temperature Control 2 Feedback Circuit Short to Ground or Open
DTC B3761 06
- Air Flow Control 3 Feedback Circuit Short to Ground or Open
DTC B3773 06
- Air Flow Control 7 Feedback Circuit Short to Ground or Open
Diagnostic Fault Information
