2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2126
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Testing
1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and
15.0 volts.
瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests
and General Diagnostics/Charging System Test).
2. Ignition OFF, disconnect the harness connectors at the ECM.
3. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms of resistance between
the ground circuit terminal 73 X1 and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
4. Verify that a test lamp illuminates between the B+ circuit terminal 20 X1 and ground.
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
5. Install a 3A jumper wire between the PWR/TRN relay control circuit terminal 59 X1 and ground.
6. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminals listed below and ground.
* Terminal 19 X1
* Terminal 47 X1
瀚慖f the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
7. If all circuits test normal, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning)for ECM replacement, setup, and programming.
FPCM
DTC P0562 (FPCM)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0562
- System Voltage Low - FPCM
Diagnostic Fault Information
Circuit/System Description
The fuel pump control module (FPCM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to
