2010 Cadillac Truck SRX AWD V6-3.0L Page 879
* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, programming and setup
C1100
DTC C1100
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptors
DTC C1100 00
- Brake Pressure Sensor 2 Malfunction
DTC C1100 01
- Brake Pressure Sensor 2 Short to Battery
DTC C1100 02
- Brake Pressure Sensor 2 Short to Ground
DTC C1100 08
- Brake Pressure Sensor 2 Performance - Signal Invalid
DTC C1100 09
- Brake Pressure Sensor 2 Too Fast Transitions
DTC C1100 5A
- Brake Pressure Sensor 2 Not Plausible
Diagnostic Fault Information
Circuit/System Description
The brake booster vacuum sensor measures the vacuum in the brake booster assembly. The electronic brake control module (EBCM) supplies a 5 V
reference and a low reference circuit to the brake booster vacuum sensor. The vacuum sensor supplies a voltage signal in relation to the pressure in
the brake booster to the EBCM.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
C1100 00
The vacuum sensor signal is out of the specified range.
C1100 01
The EBCM detected a short to voltage on the vacuum sensor 5 V reference circuit.
C1100 02
The EBCM detected a short to ground on the vacuum sensor 5 V reference circuit.
C1100 08, C1100 09, and C1100 5A
