2010 Cadillac Truck Escalade RWD V8-6.2L Page 2106
* A scan tool output control is not active.
* The system voltage is between11-18 V.
* DTC P0506 and P0507 run continuously when the above conditions are met for greater than 10 s.
Conditions for Setting the DTC
P0506
The actual idle speed is approximately 90 RPM lower than the desired idle speed.
P0507
The actual idle speed is approximately 180 RPM greater than the desired idle speed.
Action Taken When the DTC Sets
DTCs P0506 and P0507 are Type B DTCs.
Conditions for Clearing the MIL/DTC
DTCs P0506 and P0507 are Type B DTCs.
Diagnostic Aids
* A stalling condition can cause DTC P0506 to set.
* An intermittent vehicle speed sensor (VSS) signal can cause DTC P0507 to set.
* An intermittent clutch pedal position sensor signal, if equipped, can cause DTC P0506 to set.
Reference Information
Schematic Reference
Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, observe the DTC information with a scan tool. Verify there are no other DTCs set.
瀚慖f a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble
Code (DTC) List - Vehicle) for further diagnosis.
Note: The engine must run for greater than 60 s, then idle at a steady state for an additional 10 s before comparing the actual and desired
engine speed parameters.
2. Idle the engine at the normal operating temperature. Compare the Desired Idle Speed to the actual Engine Speed with a scan tool. The actual
Engine Speed should not be less than 100 RPM of the Desired Idle Speed or 200 RPM greater than the Desired Idle Speed.
3. Allow the engine to idle within the Conditions for Running the DTC. DTC P0506 or P0507 should not set.
4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
