2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 695
3. Test for infinite resistance between the following terminals:
* 30 and 86
* 30 and 87
* 30 and 85
* 85 and 87
瀚慖f not the specified value, replace the relay.
4. Test for less than 5 ohm between terminals 30 and 87A.
瀚慖f greater than the specified range, replace the relay.
5. Install a 10 A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for
less than 5 ohm between terminals 30 and 87.
瀚慖f greater than the specified range, replace the relay.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming
* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay
Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power
Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))
B3806
DTC B3806
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC B3806 00
- High Beam and Headlamp Flash Select Circuit Malfunction
Diagnostic Fault Information
Circuit/System Description
The BCM monitors the voltage level within the high beam signal circuit and the flash to pass signal circuit. When the turn signal/multifunction
switch is moved to the high beam position or to the flash to pass position, the voltage within the appropriate signal circuit drops to less than 1 V.
The BCM will detect the voltage drop and will command the headlamp high beams to turn ON or OFF.
Conditions for Running the DTC
Battery voltage must be between 9-16 V.
Conditions for Setting the DTC
