2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2503
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Steering Wheel Control Switch Assembly Replacement (See: Accessories and Optional Equipment/Sensors and Switches - Accessories and
Optional Equipment/Steering Mounted Controls Assembly/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming
P0567
DTC P0564, P0567, or P0568
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0564
- Cruise Control Multifunction Switch Circuit
DTC P0567
- Cruise Control Resume Switch Circuit
DTC P0568
- Cruise Control Set Switch Circuit
Diagnostic Fault Information
Circuit/System Description
The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate
and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.
The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data
message to the ECM indicating the status of the cruise control switches.
Conditions for Running the DTC
* The ignition is ON.
* The cruise switch is ON.
Conditions for Setting the DTC
P0564
The ECM detects an invalid voltage signal on the cruise control switch signal circuit for greater than 2 seconds.
