2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2516
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for DTC P254F.
Circuit/System Testing
Note: An intermittent or momentary, less than 1 s, loss of system voltage during throttle tip-in may set DTC P060D.
1. Ignition ON, clear the DTC information with a scan tool. Observe the scan tool DTC information. Verify that DTCs P0602 or P2610 do not
fail this ignition cycle.
瀚慖f DTC P0602 failed this ignition, reprogram the ECM. Refer to Control Module References (See: Testing and Inspection/Programming
and Relearning). If DTC P0602 resets, replace the ECM.
瀚慖f DTC P2610 failed this ignition, test the ECM ignition, battery positive voltage, and ground circuits for an open/high resistance or a
short to ground. If the circuits test normal, replace the ECM.
2. Ignition ON, observe the DTC information with a scan tool. Verify DTCs P0601, P0603, P0604, P0606, P0607, P060D, P062F, or P16F3 do
not set this ignition cycle.
瀚慖f any of the DTCs set this ignition cycle, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, programming and setup
2ML70 - Automatic Transmission
DTC P0601-P0606, P060B, or P062F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0601
- Transmission Control Module (TCM) Read Only Memory (ROM)
DTC P0602
- Transmission Control Module (TCM) Not Programmed
DTC P0603
- Transmission Control Module (TCM) Long Term Memory Reset
DTC P0604
- Transmission Control Module (TCM) Random Access Memory (RAM)
DTC P0606
- Transmission Control Module (TCM) Internal Performance
DTC P060B
- Control Module Analog to Digital Performance
DTC P062F
- Transmission Control Module (TCM) Long Term Memory Performance
Circuit/System Description
This is an internal fault detection of the transmission control module. This fault is handled inside the transmission control module and no external
circuits are involved. The transmission control module is part of the control solenoid valve assembly, and is not serviced separately.
Conditions for Running the DTC
* The control solenoid valve assembly runs the program to detect an internal fault when the key is ON or the engine is running.
