2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2515
P0606, P0607
* The ignition switch is in Run or Crank positions.
* The system voltage is more than 6.0 V.
* These DTCs run continuously when the above conditions are met.
P060D
* The ignition switch is in Run or Crank.
* The system voltage is more than 6.0 V.
* Reduced engine power is inactive.
* DTCs P2120, P2122, P2123, P2125, P2127, P2128, P2138 are not set.
* DTC P060D runs continuously when the above conditions are met.
P16F3
* The ignition is ON or the engine is operating.
* DTC P16F3 runs continuously when the above condition is met.
P2610
* The intake air temperature is between -40 to +125掳C (-40 to +257掳F).
* DTC P2610 runs on ECM Power Down.
Conditions for Setting the DTC
The ECM detects an internal failure or incomplete programming for more than 10 s.
Actions Taken When the DTC Sets
* DTCs P0601, P0602, P0603, P0604, P0606, P060D, P062F, and P16F3 are Type A DTCs.
* DTC P0607 is a Type C DTC.
* DTC P2610 is a Type B DTC.
Conditions for Clearing the MIL/DTC
* DTCs P0601, P0602, P0603, P0604, P0606, P060D, P062F, and P16F3 are Type A DTCs.
* DTC P0607 is a Type C DTC.
* DTC P2610 is a Type B DTC.
Reference Information
Schematic Reference
Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description ( See: Hybrid Drive
Systems/Description and Operation/Hybrid Modes of Operation).
2. Ignition ON, verify the scan tool hood position parameter displays Open.
瀚慖f the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
