Friday, February 7, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Technical Service Bulletin # 09-08-110-011B Date: 110506

2010 Cadillac CTS Sedan AWD V6-3.6L Technical Service Bulletin # 09-08-110-011B Date: 110506



Interior - Door Lock Lever Bezel Loose Or Detached



TECHNICAL



Bulletin No.: 09-08-110-011B



Date: May 06, 2011



Subject: Front or Rear Door Lock Lever Bezel Loose or Detached (Replace Bezel)



Models:



2008-2011 Cadillac CTS, CTS-V



Supercede:



This bulletin is being revised to add the 2011 model year. Please discard Corporate Bulletin Number 09-08-110-011A (Section 08 - Body and



Accessories).



Condition



Some customers may comment that the trim (bezel) around the manual lock lever located on the door panel near the window is loose or has become



detached.



Cause



This condition may be caused by a weakening of the heat stake tab fastening the bezel to the trim panel.



Correction



Important



Do not replace the door trim panel assembly. Replace only the bezel.



1. Remove the affected door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement in SI.



2010 Cadillac CTS Sedan AWD V6-3.6L Page 139



2. Prepare the mounting area of the trim panel. Use a utility knife or similar tool to remove the residue from the original bezel heat stake. Use



care to not damage the mounting area on the trim panel.



3. Clean the mounting surfaces of trim panel and the bezel. Be sure to follow the adhesive manufacturer's procedure.



4. Position the new bezel onto the trim panel. Use the impression in the soft outer trim surface for proper alignment.



5. Clamp the bezel into position on the trim panel as shown.



6. Apply the adhesive to the area where the bezel mounting tab protrudes through the opening in the trim panel. For this application, use a



two-part extra-fast setting epoxy, such as Hardman Double/Bubble Extra Fast Setting Epoxy*, or the equivalent.



7. Allow the adhesive to fully cure per the manufacturer's instructions.



8. Trim the excess mounting tab material to prevent interference when reinstalling the trim panel.



9. Reinstall the affected door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement in SI.



10. With the trim panel reinstalled, verify the operation of the lock lever.



* We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does



not endorse, indicate any preference for, or assume any responsibility for the products or material from this firm or for any such items that may be



available from other sources.



Parts Information



* For product information contact: www.hardmanadhesives.com (international customers ONLY should contact Frank.Lee@royaladhesives.com)



2010 Cadillac CTS Sedan AWD V6-3.6L Page 140



Warranty Information



For vehicles repaired under warranty, use the table.