2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1431
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of
the cruise control switches. The parameter should toggle between On, Off, Resume, Set, and Cancel as the applicable switch is pressed.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the S70L steering wheel control switch-left.
2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.
瀚慖f less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9
BCM.
3. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 2.
瀚慖f less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace
the K9 BCM.
4. Ignition OFF, disconnect the X1 harness connector at the K9 BCM.
5. Test for infinite resistance between the signal circuit terminal 3 and ground.
瀚慖f less than the specified value, test the signal circuit for a short to ground.
6. If all circuits test normal, test or replace the S70L steering wheel control switch-left.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Cruise Control Switch Replacement (See: Cruise Control/Cruise Control Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming
P0568
DTC P0564, P0567, or P0568
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptors
DTC P0564
- Cruise Control Multifunction Switch Circuit
DTC P0567
- Cruise Control Resume Switch Circuit
DTC P0568
- Cruise Control Set Switch Circuit
Diagnostic Fault Information
