2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1998
* The engine speed is greater than 400 RPM for 2 s.
* The transmission is not in emergency mode.
* Driving in D range.
* TCM communication is normal.
* The Automatic Transmission Fluid Temperature is more than 20掳C (68掳F).
* SLU current is more than 0.85 A.
* SLU current is not changed.
P2763
* The ignition voltage is 10.2-15.5 V.
* The engine speed is greater than 400 RPM for 2 s.
* The transmission is not in emergency mode.
* Driving in D range.
* TCM communication is normal.
* DTC P2764 is not set.
P2764
* The ignition voltage is 10.2-15.5 V.
* The engine speed is greater than 400 RPM for 2 s.
* The transmission is not in emergency mode.
* Driving in D range.
* TCM communication is normal.
* DTC P2763 is not set.
Conditions for Setting the DTC
P2759
Deviation between commanded current and feedback current
P2762
The TCM detects the error current more than 80 mA for 2.75 ms.
P2763
The TCM detects at least 5 times less than 23 mA current consumption of the SLU control circuit for 100 ms.
P2764
The TCM detects at least 5 times more than 1.333 A current consumption of the SLU control circuit for 100 ms.
Action Taken When the DTC Sets
P2759, P2762
* DTCs P2759 and P2762 are Type B DTCs.
* The TCM turns OFF all solenoids.
* The TCM allows the vehicle to operate only in second gear and "R" range after a stop.
P2763, P2764
* DTCs P2763 and P2764 are Type B DTCs.
* No self learning function.
* The TCM turns OFF all solenoids.
* The TCM allows the vehicle to operate only in second gear and "R" range after a stop.
Conditions for Clearing the DTC
P2759, P2762
* DTCs P2759 and P2762 are Type B DTCs.
* The TCM detects the error current less than 50 mA for 2.75 ms.
P2763, P2764
* DTCs P2763 and P2764 are Type B DTCs.
* The current consumption of the SLU control circuit is 0.1-1.1 A for 500 ms.
Diagnostic Aids
When attempting to set solenoid electrical DTCs, ensure the TCM is warmed up and the transmission is operated in 2nd gear long enough to ensure
a 3掳C (5掳F) increase in TCM substrate temperature. This will place the TCM in the optimal condition to test solenoid electrical DTCs.
