Saturday, December 7, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1417

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1417



Circuit/System Description



The engine control module (ECM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components,



and incorrect data may occur when the voltage is out of range.



Conditions for Running the DTC



The ignition is ON.



Conditions for Setting the DTC



The ECM detects that the battery voltage is less than 2.54 V for 5 seconds.



Action Taken When the DTC Sets



DTC P0560 is a C type DTC.



Conditions for Clearing the DTC



DTC P0560 is a C type DTC.



Diagnostic Aids



A low voltage DTC in multiple modules indicates a concern in the charging system.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Engine running, accessories OFF, measure and record the battery voltage at the C1 battery terminals. The voltage should be between 12.6 and



15.0 V.



瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests



and General Diagnostics/Charging System Test).



2. S39 Ignition Switch OFF, disconnect the harness connectors at the K20 ECM.



3. S39 Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ohms between the